Sunday, October 27, 2013
2002 Buick Rendezvous the truck cut the Panel to replace
Tools required J 38778 door trim Pad and decorate with a clip Remover removal procedure
1. open the door.
2. remove the power window switch.
3. remove the screws from the front door of bezel
4. use the J 38778 remove exterior trim panel.
1. place the electrical harness connectors.
2. remove the exterior trim panel from the vehicle.
The installation procedure important: before you install the front door to the bezel clamps in the bezel, rejects the old and replace with a new bezel clamps.
1. install a new front door exterior trim panel retainers.
2. route the electrical connectors through the exterior trim panel.
3. align the bezel, the internal ones, are driven by the door handle through the exterior trim panel.
4. install the exterior trim panel to the top of the top of the inner door panel, press down on it until the exterior trim panel is fully seated.
5. install the exterior trim panel by pressing firmly in the bracket clips until the clips are in place around the exterior trim panel. Caution: the fastener notice in cautions and notices, see. 6. install the screws in the front door exterior trim panel. Tighten the screws 2 n. m (18 lb in).
7. connect the power supply to the window on the top.
Download manual here
