Sunday, October 27, 2013
2007-2008 Dodge Avenger Exhaust System Installation Manual
This manual is how to install Exhaust System in 2007-2008 Dodge Avenger. Installation Summary :
Exhaust System Installation
1. Place a clamp over the expanded end of the front muffler assembly and set it into position as shown in figure 3 making sure to install the hanger into the rubber isolator. Do Not tighten the clamp.
2. Place a clamp over the expanded end of the y pipe assembly and set it into position as shown in figure 4. Do Not tighten the clamp.
3. Place a clamp over the expanded end of the left rear muffler assembly and set it into position as shown in figure 5 making sure to install the hanger into the rubber isolator. Do Not tighten the clamp.
4. Clip the ground strap onto the left muffler as shown in figure 6.
5. Place a clamp over the expanded end of the right rear muffler assembly and set it into position.
6. Check your exhaust system for proper clearance under the vehicle and also for tip alignment.
7. Once position has been determined to be correct, tighten the Accuseal clamps to 32-35 ft. lbs. making sure the clamps openings are not over any of the notches in the pipes.
2007-2008 manual here
