Sunday, October 27, 2013
2012 Honda Fit engine block heater installation guide
Installation of the 2012 Honda Fit engine block heater installation guide
1. make sure that you have the anti-theft code (if equipped) the navigation unit and the audio system then write to the radio channels.
2. disconnect the negative cable on the battery.
3. allow the engine and all the cooling system components to cool.
4. place a clean drain the entire radiator drain plug underneath the radiator then remove the drain plug on the bottom of the cooling fluid removal. Remove the radiator CAP to increase the flow of information. The coolant will damage the paint. Quickly rinse the spilled coolant painted surfaces.
5. to remove, lift the vehicle's engine splash shield (the screw and three clips).
6. using the 19 mm socket, remove the drain bolt and washer to the engine. The coolant flows out of the hole in the left engine of the jackets, when the plug is removed. Keep the plug; It will be used, if an engine block heater to be removed. Note: use the new washing machine if the drain bolt is installed again.
7. install the aluminium engine block heater with washer to the engine using a 24 mm socket 100 mm (4 inches). The torque of an engine block heater to 60 N · m (44 high pressure). Using extension, more than 100 mm (4 inches) to give you a false torque reading.
8. measure and mark the heater harness step in JavaScript. Install the wire tie Shown in each of the measurements of the heater harness clip.
download here
